Recently, Chinese researchers developed a new way to improve the room-temperature thermoelectric performance of AgBiSe₂ by tuning its band structures using intrinsic and extrinsic point defects.

This work was done by ZHANG Yongsheng’s research team with Institute of Solid State Physics under Hefei Institutes of Physical Science.

Thermoelectric materials enable direct conversion between thermal and electrical energy, and they offer a promising solution for harvesting waste heat to use as electrical power. Compounds with maximum ZT values at relatively high temperature (>900K) are suitable for medium- and high-temperature applications. However, few materials are suitable for low-temperature (~300K) applications.

Recently, the hexagonal phase of AgBiSe₂ has been attracting increasing attention for its room-temperature applications due to the intrinsic low lattice thermal conductivity (0.45 W/mK at 300 K). Unfortunatelly, there are two main issues should be considered. The one is that conducting behavior of AgBiSe₂ is still umbiguous, which hinders its thermoelectric property tuning using carrier concentrations. The other is that its peak ZT velue is too low (less than 0.1) to be commercially used.

For the conducting behavior, researchers calculated defect formation energies of different intrinsic charged point defects at different chemical potentials in AgBiSe₂, and found that the Ag vacancy defect was the most stable intrinsic defect in the Ag-rich and Se-rich conditions. Thus, the acceptor defects (Ag vacancy) lead to the p-type conduction behavior of AgBiSe₂. The team clarified the the conducting behavior of AgBiSe₂.

To improve the thermoelectric performance of AgBiSe₂ at room temperature, enhancing the power factor of the compound is an essential way.

Based on scrutinizing the band structures of AgBiSe₂, two kinds of methodologies have been developed to modify its band structure for achieving high band degeneracy and large power factors, one was shifting the Fermi level into the valence band using intrinsic defects, and the other was converging several valence-band maxima by introducing extrinsic defects. Eventually, the team found that the intrinsic Ag vacancy was helpful to significantly increase the power factor, leading to a large ZT for Ag vacancy-doped AgBiSe₂: the maximum ZT value increased to 0.3–0.5 at near room temperature.

Additionally, based on analyzing the bonding characters and atomic energy levels in the compound, the team predicted that the thermoelectric properties of AgBiSe₂ could be improved by introducing Cu, Rh, and Pd.

Their work provides methodologies to improve the room-temperature thermoelectric applications of AgBiSe₂ by tuning its band structures using intrinsic or extrinsic defects.

The research was supported by the financials of National Natural Science Foundation of China. The calculations were performed at the Center for Computational Science of CASHIPS, the ScGrid of the Supercomputing Center, and the Computer Network Information Center of the Chinese Academy of Science.

Link to the paper: Thermoelectric optimization of AgBiSe₂ by defect engineering for room-temperature applications

(a) Calculated band structure of the pristine AgBiSe₂ along high-symmetry points in BZ. The calculated isoenergy surfaces for AgBiSe₂ near the VBM are shown at (b) VBM-0.01 eV, (c) VBM-0.06 eV, and (d) VBM-0.11 eV. (Image by FENG Zhenzhen)

(a) Projected density of states of AgBiSe₂. (b) Schematic of interatomic interactions between the main valence states for energy-band formation, where the bonding and antibonding states are formed in the shaded region. (Image by FENG Zhenzhen)

Contact:

ZHOU Shu

Hefei Institutes of Physical Science (http://english.hf.cas.cn/)

Email: zhous@hfcas.ac.cn